- Product Specs
- Handlebar Definitions
WILL NOT WORK WITH 2015+ FLTR
The Menace Ape features a new, more aggressive, bend in the uprights. Similar to the Evil Ape with its sharp corners this bar has more attitude than any other bar in our lineup.
Now in 1.50" diameter, these bars will require a 1.50" diameter riser please see our Riser (<--Click here) section for options.
These bars are also equipped for Electronic throttle and drilled for internal wiring.
Grip sections are 1.00" in diameter (will fit stock harley controls)
This product is only available on CarliniDesign.com. No other seller carries this product.
Patented Design! # D687753 - This is a Carlini Patented Design. Made and manufactured in the USA!
** The photo used for this product is a stock photo and does not show the provision for hydraulic clutch, rest assured this bar has a relief for a fluid cylinder on BOTH sides**
- Thickness: 1.50" in.
- Width: 36" in.
- Pullback (depth): 7" in.
- Rise (height): 16" in.
-Center Width: 11.5" in (measured from center of the bend to center of the bend)
- Grip sections taper to 1" diameter to be used with 1" hand controls and grips.
- Bars are Pre-drilled for internal wiring.
- Handlebars are equipped for Throttle By Wire (Electronic Throttle)
Width - The length between the left and the right ends of the handlebar.
Rise (height) - The length from the base of the handlebar to the top.
Pullback (depth) - Viewing from the side, the distance from the front to the back end of the handlebar grips.
Thickness - the diameter of the handlebar.
Center Width - The width from center of bend to center of bend at the base of the bar, or for sharp cornered bars from outside of the corner to outside of corner.